Sorry!
There seems to be a problem connecting to our database. Please give us a few minutes to remedy the problem. Thank you.

New Release: Round LED Systems

Last Updated on Saturday, 05 June 2010 19:37 Written by Brian McCullough

They are here!

L.E.D. systems for the Lucas Automotive front markers and Rear tail lamps for British cars and kits cars utilizing the large round British marker lighting systems.

Built to increase your safety by intensifying the light output by Four times in All directions, not just straight rearward. This is done while increasing reliability of your lighting system by removing the need for a hot glowing element supported by a spring pushing against the back of the bulb in a socket that tends to corrode with a ground that is undeniably questionable in even a newly restored classic.

The System, sold as a set, is designed to fit into the following fixtures without alteration the following: MGA Front (amber), MG Magnette Rear (red), Cobra and Cobra Replica Rear (2 red, 2 amber), Austin Healey 3000 Rear (red), some later Austin Mini Front (Amber). If you do not see your application, Contact us for further information.

For Many British car owners, this means they can fit the Bright L.E.D. System to both the front AND rear of their car cutting power needs to the parking lamps, lowering the required load through the brake and headlamp switches. This in turn brightening up your headlamps without installing relays because the load going through the switch is Greatly reduced!

• 85% less amps requirement from traditional incandescent (OEM type) lighting
• Far brighter in ALL directions. Consider the S.U.V. Driver whose line of sight is far over the standard British tail lamps
• Does not overheat and melt tail lamp lenses like other systems do
• System has ground wire to eliminate the need for a faulty socket grounds
• Installation is 100% reversible
• No need for an unoriginal 3rd brake light at an additional expense and additional load to a system that is already nearing it maximum electrical capabilities
• ”Hyperactive” lighting- lighting comes to full brightness FAR in advance of standard bulbs which gives the driver behind you additional reaction time
• Operates under higher and lower battery voltage consistently bright and safely which standard bulbs cannot operate at
• Diode protected from reverse polarity- cannot be damaged by connecting the incorrectly
• Sold for both Positive and Negative applications
• Our LEDs are clear- not coloured until lit up- they go Unnoticed when off but light the tail lamps up correctly when lit- red for red lens so they stay red. A white type LED would cause a pink colour which would be very unnatural indeed!

Tools required for installation: None unless you have a lens with a posidrive or phillips screw.
If you can change a light bulb, you can install this kit. No electrical tools, no soldering, nothing- just connect the colour coded wiring.

Installation instruction included.


NOTE: Lenses shown are MGA clear front and MG Magnette rear. The units have also been  fit to Healey 3000 lower rear, Cobra kits with Lucas tail-lamps.