Flywheel and clutch kit, Cast Flywheel system

Our Clutch Kit - Flywheel Combo in a one step form of individual parts you will find in our store.

This setup includes:
3-210 New Clutch kit for GM V6 or V8 T5

3-110 New Rear Drive *Internal* balance flywheel, the lightest stock RWD flywheel for increased power to the rear wheels. Why use a Camaro flywheel that was built for a 3,600 pound car? Don't! This unit is better suited for cars under 2800 lbs.

3-200 New GM Flywheel to Crank bolts

3-270 New clutch plate bolt set

and our very own
3-330 Hydraulic Throw Out Bearing assembly (HTOB) which includes instructions, shims, bolts, lines and fittings needed to connect right to the stock master cylinder.

This assembly allows installation of Engine: 1987-1995 Internal Balanced RWD or any 3.4L GM Performance Crate Motor V6 into any car using any form of Gearbox: GM T5 Borg-Warner 1983-2002 5 speed.

NOTE: **The 26 spline clutch may be replaced with a 14 spline clutch upon request. This must be done by email or telephone to insure correct kit is sent if ordering a 14 spline clutch disc.

*The external balanced flywheel for 1982-1986 model years can be substituted for the internal on older motors for an additional $40 extra.

Additional components potentially required for your system may include our following part numbers:
3-410 gearbox mount
3-220 Gearbox bolt kit, GM T5
3-260 Bellhousing, 60 degree V6 to all GM T5 and some Ford type T5
1-440 Reverse lamp switch plug/pigtail